C-LITE C-PHB-C-L2F-SCCT Serie Instructions D'installation

INSTALLATION INSTRUCTIONS
C-PHB-C-L2F-SCCT Series
With Emergency Backup
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. SUITABLE FOR DAMP LOCATIONS.
CONVIENT AUX EMPLACEMENTS HUMIDES
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
CHAIN OR CABLE MOUNT
(FOR FIXTURES WITHOUT FACTORY INSTALLED
6FT CORD)
NOTE: Fixture must be suspended a minimum of 12" below mounting
surface.
1. Attach support chains or cables (supplied by others or purchased
as Chain Kit Mounting Accessory) to the (2) supplied V-hooks.
2. Insert the ends of the V-hooks through the larger slotted holes on
the top of the fixture and pass the ends of the hooks through the
smaller slotted holes at both ends of the fixture (See Figure 2).
To prevent V-hooks from disconnecting from the fixture, pinch the
ends of the V-hooks shut.
3. Attach opposite ends of support chains or cables to mounting
surface. Make sure mounting surface and customer supplied
hardware can support the weight of the fixture.
4. Remove screw from wiring access cover to allow for removal of
cover. See Figure 3 on next page.
5. Conduit:
Insert leads from conduit through 1/2" knockout in wiring access
cover. Secure conduit to cover with conduit nut on opposite side of
the cover. See Figure 4.
6. See Electrical Connections section for wiring.
following:
http://lighting.cree.com/warranty
Document LPN00708X0002A0_A
Created By: TMT
7. Replace wiring access cover. Make sure both ends of wiring
access cover are engaged with the top of the back cover. Secure
cover in place using screw removed in Step 4.
8. Select the desired CCT and wattage using the dip switches on the
fixture back cover. See Figure 5.
NOTE: Factory settings are highest wattage and 4500K.
CHAIN OR CABLE MOUNT (FOR FIXTURES WITH
FACTORY INSTALLED 6FT CORD)
NOTE: Fixture must be suspended a minimum of 12" below mounting
surface.
1. Attach support chains or cables (supplied by other or purchased
as Chain Kit Mounting Accessory) to the (2) supplied V-hooks.
2. Insert the ends of the V-hooks through the larger slotted holes on
the top of the fixture and pass the ends of the hooks through the
smaller slotted holes at both ends of the fixture. See Figure 2.
3. Attach opposite ends of the support chains of cables to the
mounting surface. Make sure the mounting surface and customer
supplied hardware can support the weight of the fixture.
4. See Electrical Connections section for wiring.
5. Select the desired CCT and wattage using the dip switches on the
fixture back cover. See Figure 5.
NOTE: Factory settings are highest wattage and 4500K.
FIGURE 1
FIGURE 2
FIGURE 3
| 866.924.3645
Date: 1-19-2023
Back Cover