C-LITE C-TR-B-BT Serie Instructions D'installation

INSTALLATION INSTRUCTIONS
C-TR-B-BT LED Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. Suitable for damp locations.
Convient aux emplacements humides.
4. Min. 90°C supply conductors.
Les fils d'alimentation 90°C min.
5. Access above ceiling required.
Acces requis au-dessus du plafond.
6. Inherently protected.
Protection inherente.
7. Type IC. Vapor barrier must be suitable for 90°C.
Type IC. Le pare-vapeur doit convenir pour 90°C.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
http://lighting.cree.com/warranty
Document:
LPN00606X0001A1_A
Created By:
TMT
INSTALLATION
1. Locate desired fixture location in ceiling grid.
2. Remove existing ceiling panel at chosen location. Remove
adjacent ceiling panel to allow for wiring access from above.
3. Place fixture into T-bar ceiling grid. Bend clips on sides of fixture
to engage with T-bar support grid. See Figure 1. If necessary, use
side cutters to adjust each tab to height of T-grid.
4. Secure fixture to grid in compliance with state and local codes.
5. Remove screw on driver wiring chamber, slide cover to side, and
remove cover. Set screw and cover aside to be reinstalled later.
6. Remove appropriate 1/2" knockout(s) to allow for entry of supply
wiring into wiring chamber.
7. Make wiring connections per the Electrical Connections section.
8. Reattach wiring chamber cover with screw that was removed in
Step 5 above.
9. Select the desired CCT and wattage using the dip switches on the
top of the driver enclosure. See Figure 2.
10. Replace adjacent ceiling panel that was removed in Step 2 above.
FIGURE 1
FIGURE 2
| 866.924.3645
Date:
8-19-2021
Factory Settings:
5000K, 25W