C-LITE C-VT-C-LIN4 Serie Instructions D'installation

INSTALLATION INSTRUCTIONS
C-VT-C-LIN4 Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié..
3. SUITABLE FOR WET LOCATIONS.
CONVIENT AUX EMPLACEMENTS MOUILLES.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
http://lighting.cree.com/warranty
Document: LPN00856X0001A1_A
Created By: TMT
INSTALLATION
1. Remove lens by disengaging (12) lens clips holding the lens in
place. See Figure 1.
2. Rotate the (4) thumb screws 90 degrees to remove the LED panel.
LED panel can be lifted away from housing base, but will be
retained by plastic straps. Do NOT touch LEDs.
3. Drill out appropriate knockout(s) at the end(s) of the fixture
for attachment of customer supplied cord grip(s) or conduit
connector(s.)
4. Attach cord grip(s) or conduit connector(s) into holes opened in
Step 3. Make sure wiring entry points are properly sealed with a
high grade caulking material, such as silicone rubber, to prevent
water entry.
5. Attach the two supplied mounting brackets to the mounting surface
using appropriate customer supplied screws. Bracket spacing is
32".
6. Attach one side of the fixture to both brackets by inserting bend in
bracket into grooves in housing base. Secure fixture by snapping
other side of the fixture onto clips. A "click" should be heard when
the second side of the fixture is secured.
7. Wire the fixture per the Electrical Connections section.
8. Reassemble the LED panel to the housing and secure by rotating
the (4) thumb screws from Step 2. Be careful not to touch LEDs.
Make sure no leads are pinched.
9. Replace the lens. Make sure the (12) plastic lens clips are properly
seated when locking the lens in place.
10. Supply power to the fixture.
FIGURE 1
Housing base
B
Lens
| 866.924.3645
Date 9-26-2023
Lens clips
mounting bracket grooves