Télécharger Imprimer la page

C-LITE C-HB-C-RD Serie Instructions D'installation page 3

Publicité

INSTALLATION INSTRUCTIONS
C-HB-C-RD Series
INSTALLATION OF WIRE GUARD ACCESSORY
Requires use of Wire Guard Accessory Kit
NOTE: Wire guard accessory requires use of reflector for
mounting.
NOTE: Wire guard accessory can not be used in combination with
a lens accessory.
1.
Position wire guard below reflector, aligning attachment nuts on
wire guard with holes in reflector. See Figure 5.
2.
Thread (4) supplied M4x8 mm round head screws through holes
in reflector and into threaded nuts in wire guard. Tighten screws to
retain wire guard.
NOTE: Do NOT overtighten screws to prevent damage to reflector.
INSTALLATION OF REFLECTOR ACCESSORY
(REQUIRES USE OF ALUMINUM OR PRISMATIC
REFLECTOR ACCESSORY
1.
Position the reflector under the housing.
2.
Align the (4) thru holes on the reflector with the (4) threaded holes
on the bottom of the housing. See Figure 6.
3.
Thread (4) #8-32 x 5/16 screws through the holes in the reflector
and into the threaded holes on the bottom of the housing. Tighten
the screws to retain reflector. See Figure 7.
NOTE: Do NOT overtighten screws to prevent damage to the
reflector.
PENDANT MOUNTING- NON-EMERGENCY UNITS
(Requires use of Pendant Mount Accessory)
1.
Thread the pendant mount accessory into the tapped hole on top
of the fixture. See Figure 8.
2.
Tighten security screw on the hub of housing against the pendant
mount to lock it in place.
3.
Thread pendant mount accessory onto threaded end of 3/4"
pendant.
4.
Tighten security screw on the pendant mount accessory to secure
fixture to pendant.
5.
Attach supplied safety cable to fixture and to mounting surface
using safety hook. See Figure 9.
6.
Splice fixture cord leads to supply
Electrical Connections section. For dimming applications (120-
277 only), second cord with pink and violet leads will also be used.
NOTE: UH (347-480V) luminaires may only be dimmed using the
motion sensor accessory.
leads in junction box per
http://lighting.cree.com/warranty
Document
LPN00617X0001A3_A
Created By:
TMT
FIGURE 5
Wire Guard
FIGURE 6
FIGURE 7
(4) #8-32 x 5/16 screws
FIGURE 8
|
866.924.3645
Date:
01-24-2024
Reflector
Pendant

Publicité

loading