Publicité
9027970
2.
Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Using an air compressor or dust vacuum, frequently blow out any
dust that accumulates inside the motor.
6.
Apply a coat of paste wax to the table and column to help keep the
surface clean & help avoid rust.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
LUBRICATION
All of the drill press ball bearings are packed with grease at the factory.
They require no further lubrication. Periodically lubricate the gear and
rack for the table elevation. Lower spindle to maximum depth and oil
moderately once every three months.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
16
20 in. Floor-Mount Drill Press
For technical questions call 1-800-665-8685
V1.1
Publicité
