Publicité
9027970
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification
Key. Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point
in an illustration or image.
1.
Place the column assembly on base (E) and align holes in column
support with holes in base. Secure the column with four bolts and
washers (Fig. 2).
2.
Take off collar and table (D) and fasten the table bracket (C)
together with the table (Fig. 3).
3.
Install the collar and fix it firmly (Fig. 4).
4.
Fix handle (I) with attached set screw (Fig. 5).
5.
Install clamp bolt to fix table bracket (Fig. 6).
6.
Place the head assembly (A) over the column (B) and slide into
position.
7.
Align head frame with table and base and fix the set screws in right
side of the head to lock head into position then. Tighten with an
Allen wrench (N) (Fig. 7).
8.
Screw knob on each feeding handle (H). Install them into hub of
pinion shaft (Fig. 8).
10
20 in. Floor-Mount Drill Press
Fig. 2
Fig. 5
Fig. 3
Fig. 6
For technical questions call 1-800-665-8685
V1.1
Fig. 4
Fig. 7
Publicité
