Publicité
English
Fig. G
Cleaning and emptying the product
WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick empty
method and a thorough clean method.
For a quick empty (Fig. H, I)
•
Figure h - Press the dust bowl release button
handle and remove the dust bowl.
Fig. H
•
The top of the bowl is open when the bowl is removed
so that dust can be easy dumped without touching the
filter.
•
Figure i - Empty the dust from the bowl
•
To replace dust bowl, place it back onto the handle until
it "clicks" firmly into position.
For a more thorough cleaning, remove bowl as described
below.
Fig. I
For a more thorough cleaning (Fig. J, K)
•
Figure h - Press the dust bowl release button
handle and remove the dust bowl.
4
Downloaded from
www.Manualslib.com
1
Projectile/Respiratory Hazard:
4
.
manuals search engine
•
Remove filter from within the bowl.
Fig. J
•
Shake or lightly brush any loose dust off filter.
nOTE: The brush on the nozzle can be used to remove dirt
on the pleated filter.
•
The dust bowl
water. Allow to dry before placing back into the vac.
Fig. K
2
on the
•
Place filter back into the bowl pressing firmly to ensure
a secure fit.
•
To replace dust bowl, place it back onto the handle until it
"clicks" firmly into position.
iMPORTAnT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
•
Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
•
It is very important that the filter is correctly in position
before use.
Nozzle / Accessories (Fig. L–O)
Figure l - A crevice tool
•
can be extended as shown in Figure l by pulling the
extension piece until it locks into position.
Fig. L
6
4
on the
2
7
4
and filter can be washed in warm soapy
4
6
is built into the nozzle and
Publicité
