Instructions For Operation - Max PowerLite AKHL1050E Manuel D'utilisation Et D'entretien

3. INSTRUCTIONS FOR OPERATION

READ SECTION TITLED " SAFETY INSTRUCTIONS "
WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the possibility of dust being blown up by the exhausted air or of a fastener
flying up to the improper handling of the tool. For these reasons, safety glasses or goggles shall always be worn
when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform
to the requirements of the American National Standards Institute. ANSI Z87.1 (Council Directive 89/s86/EEC of 21
DEC. 1989) and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection.
NOTE: The information contained in this Instruction Manual is designed to assist you in the safe operation and
maintenance of the compressor.
Some illustrations in this Instruction Manual may show details or attachments that differ from those on
your own compressor.
1) INSTALLATION
1. NEVER USE THE MACHINE IN A PLACE WHERE ANY VOLATILE COMBUSTIBLE SUBSTANCE HAS
BEEN STORED.
Never use it near gasoline, thinner, gas, paint or adhesive agent, because they could be ignited or blow up.
2. NEVER USE THE MACHINE NEAR THE HEAT OF FIRE OR ANY COMBUSTIBLE SUBSTANCE.
3. NEVER USE THE MACHINE IN AN UNSTABLE PLACE.
Never use it in a place where it could move or fall of itself.
4. AVOIDING A PLACE EXPOSED TO HIGH TEMPERATURE OR THE DIRECT SUNSHINE, BE SURE TO
USE THE MACHINE IN THE WELL-VENTILATED SHADE.
Using it under high temperature or in the direct sunshine not only deteriorates its durability, but increases the
temperature of the main body, causing danger to your safety. Be sure to use it in the well-ventilated shade.
5. DO NOT INSTALL THE MACHINE IN A DUSTY(WOODEN CHIPS, ETC.) PLACE.
6. INSTALL THE MACHINE IN THE APPROPRIATE DIRECTION.
Install it appropriately.
7. NEVER INSTALL THE MACHINE IN THE RAIN OR IN A PLACE SPLASHED WITH WATER OR EXPOSED
TO HIGH TEMPERATURE.
Using it in the wet condition could cause an electric shock or a short-circuit, resulting in a fire due to burnout
or ignition.
10