Fuel Handling; Fuel - Husqvarna 525BX Manuel D'utilisation

Masquer les pouces Voir aussi pour 525BX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fuel

CAUTION! The machine is equipped with a two-stroke
engine and must always be run using a mixture of
gasoline and two-stroke engine oil. It is important to
accurately measure the amount of oil to be mixed to
ensure that the correct mixture is obtained. When mixing
small amounts of fuel, even small inaccuracies can
drastically affect the ratio of the mixture.
WARNING! Always ensure there is
!
adequate ventilation when handling fuel.
Gasoline
CAUTION! Always use high grade oil mixed gasoline
(minimum 87 RON).
When working at continuous high revs a higher octane
rating is recommended. Use good quality unleaded
gasoline.
This engine is certified to operate on unleaded
gasoline.
The lowest recommended octane rating is 87. If you
run the engine on lower octane rating than 87 so-
called "knocking" can occur. This leads to an
increased engine temperature, which can result in a
serious engine breakdown.
Husqvarna alkylate fuel
Husqvarna recommends the use of Husqvarna alkylate
fuel for best performance. Husqvarna alkylate fuel is not
available in all markets.
Ethanol blended fuel, E10 may be used (max 10%
ethanol blend). Using ethanol blends higher than E10 will
create lean running condition which can cause engine
damage.
Two-stroke oil
For best results and performance use HUSQVARNA
two-stroke oil, which is specially formulated for our
two-stroke engines. Mixture 1:50 (2%).
If HUSQVARNA two-stroke oil is not available, you
may use another two-stroke oil of good quality that is
intended for air cooled engines. Contact your dealer
when selecting an oil.
Never use two-stroke oil intended for water-cooled
outboard engines, sometimes referred to as outboard
oil.
Never use oil intended for four-stroke engines.
12 – English

FUEL HANDLING

Gasoline, litre
5
10
15
20
US gallon
1
2 1/2
5
Mixing
Always mix the gasoline and oil in a clean container
intended for fuel.
Always start by filling half the amount of the gasoline
to be used. Then add the entire amount of oil. Mix
(shake) the fuel mixture. Add the remaining amount of
gasoline.
Mix (shake) the fuel mixture thoroughly before filling
the machine's fuel tank.
Do not mix more than one month's supply of fuel at a
time.
If the machine is not used for some time the fuel tank
should be emptied and cleaned.
This engine is certified to operate on unleaded
gasoline.
Two-stroke oil, litre
2% (50:1)
0,10
0.42/0,20
0,6/0,30
0,40
US fl. oz.
2 1/2
6 1/2
12 7/8

Publicité

Table des Matières
loading

Table des Matières