Uline Metro Serie Mode D'emploi page 4

8. Place left door (8) and right door (9) panels on a
smooth, non-marring surface to prevent scratching.
Align holes in hinge (J) with pre-drilled holes in door
panels. Insert two M4 x 10 mm bolts (J) and tighten.
Repeat for three remaining hinges.
(See Figure 7)
9. Attach handles (B) to the outside of the door panels
using four M4 x 22 mm bolts (B). (See Figure 7)
10. Align holes on S-bracket (F) with pre-drilled holes in
top of left door (8). Insert two M3 x 12 mm screws (F)
and tighten. (See Figure 7)
11. Align holes on lock (F) with pre-drilled holes in right
door. Insert two M3.5 x 16 mm screws (F) and tighten.
(See Figures 7-8)
NOTE: Refer to Figure 8 for correct orientation
of lock.
Figure 7
J
8
9
Figure 8
Locked
PAGE 4 OF 15
ASSEMBLY CONTINUED
F
Inside View
Unlocked
12. Using two people, hold door panel in line with side
panel. Attach hinge (J) to inside of side panels
using four M3.5 x 14 mm screws (J). Repeat for three
remaining hinges. (See Figure 9)
Figure 9
B
13. Once door panels are attached, hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 10)
Figure 10
F
Side
Panel
Door Depth
8
Side
Door
Panel
9
Door
Door Angle
1024 IH-10295