Uline Metro Serie Mode D'emploi page 3

3. Install seven cam lock pins (D) and six dowels (G)
in left side panel (1). Insert seven cam locks (E) into
corresponding holes in back panel (5), bottom
panel (4), skirt panel (6) and top support beams (10).
Fit left side panel together with back panel, bottom
panel, skirt panel and top support beams and
tighten cam locks. Repeat for right side panel (2).
(See Figure 3)
Figure 3
5
10
D
4. Align holes on L-bracket (F) with pre-drilled holes in
top panel (3). Insert two M3 x 12 mm screws (F) and
attach using a Phillips screwdriver or drill. Align holes
on door plug (K) with pre-drilled holes in top panel
and gently tap with a rubber mallet to insert.
(See Figure 4)
Figure 4
K
PAGE 3 OF 15
ASSEMBLY CONTINUED
4
6
E
G
1
3
F
5. Attach top panel (3) to support beams using eight
M6 x 30 mm bolts (C). (See Figure 5)
6. Mount adjustable glides (A) to bottom of side panels.
(See Figure 5)
NOTE: Glides can be adjusted to compensate
for uneven floors.
Figure 5
7. Set cabinet upright. Insert four shelf dowels (H) into
corresponding holes in side panels (1, 2). Place
shelf (7) inside cabinet and ensure shelf supports
lower onto shelf dowels. Tighten shelf supports in
underside of shelves for a secure fit. (See Figure 6)
Figure 6
1
3
10
C
3
2
7
2
4
H
1024 IH-10295