For H-10306 and H-10307 storage credenza
assembly, refer to instructions included with
H-10308 storage credenza top and side frames.
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right
to lock.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing toward edge of
panel before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel. To tighten cam lock
pins, grasp lower part of cam lock pin and
tighten using a Phillips screwdriver.
TIGHTENING OF CAM LOCK PINS
NOTE: Use Phillips screwdriver to tighten cam
locks, cam lock pins and screws.
NOTE: Cam lock caps (I) can be applied once
cam locks are tightened for a finished look.
PAGE 2 OF 15
1/4 RIGHT TURN
FOR LOCKING
Hold while
tightening
ASSEMBLY
1.
Install one cam lock pin (D) in bottom panel (4).
Insert one cam lock (E) into corresponding hole
in skirt panel (6). Fit bottom panel and skirt panel
together and tighten cam locks. (See Figure 1)
Figure 1
4
2. Install two cam lock pins (D) and two dowels (G)
in back panel (5). Insert two cam locks (E) into
corresponding holes in bottom panel (4). Fit back
panel and bottom panel together and tighten cam
locks. (See Figure 2)
Figure 2
5
5
6
E
D
D
4
D
4
G
D
D
4
E
4
4
E
5
1024 IH-10295