Publicité
OPERATION
modes.
Voltage: Displays current voltage output at either the
120/240V receptacle (30A) or the 120V receptacle
(30A) and 120V receptacles (20A), depending on the
position of the voltage selector.
Frequency (Hz): Displays power output frequency in
Hertz.
Lifetime Hours: Displays the lifetime run hours.
Run Time/Maintenance: Displays current run time.
Resets to zero when shut down. Maintenance reminder
displayed when required.
Maintenance Codes:
P25 - Change engine oil
P50 - Clean air filter, Change engine oil
P100 - Change engine oil, clean air filter, replace
fuel filter
BREAK-IN PERIOD
For proper break-in, do not exceed 50% of the rated
running watts during the first five hours of operation.
Use supplied oil until first recommend oil change. Do
not use full synthetic oil during break in period. Full
synthetic oil may prevent proper breaking and seating
of the piston rings.
Vary the load occasionally to allow stator windings to
heat and cool and help seat the piston rings.
BEFORE STARTING THE GENERATOR
Confirm that:
l The generator is placed in a safe, appropriate location.
l The generator is on a dry, flat, and level surface.
l Oil and fuel levels are within safe operating range.
l All loads are disconnected from the control panel
receptacles.
DANGER
NOT move or tip the generator during operation.
STARTING THE GENERATOR
See Figure 24, 25, and 26.
l Place the generator in a safe, level location.
l Unplug all loads.
l Check oil and fuel levels. If needed add oil, refill the LP
gas cylinder, or add gasoline.
l Using the fuel selector switch, select Gasoline
Propane
.
l Move the voltage selector to 120V or 240V position.
24 | English
Fire and explosion hazard. DO
A
C
A - Voltage
B - Frequency
C - Lifetime Hours
D - Run Time/Maintenance Reminder
E - Mode Button
FIGURE 24
A - Fuel Selector Switch
B - Engine Run/Stop Switch
C - Voltage Selector
l Start the flow of your desired fuel and stop the flow from
other fuel sources.
• For gasoline, open the fuel valve and turn off the flow
of propane gas.
• For propane, open the cylinder valve on the LP gas
cylinder and turn off the flow of gasoline.
To start the generator:
or
l Put the engine run/stop switch in the RUN
E
FIGURE 23
A
B
B
D
C
position.
Publicité
