Philips SONICARE HX9911/88 Mode D'emploi page 22

Toothbrush handle

Charging travel case

Note: When the battery is completely empty, the

toothbrush switches off. Place the toothbrush on the

charger to charge it.

Note: To keep the battery fully charged at all times, you

may keep your toothbrush on the charger when not in

1 Remove the brush head and rinse the metal shaft area

with warm water. Make sure you remove any residual

Caution: Do not push on the rubber seal on the metal

shaft with sharp objects, as this may cause damage.

2 Wipe the entire surface of the handle with a damp

Note: Do not tap the handle on the sink to remove excess

1 Rinse the brush head and bristles after each use.

2 Remove the brush head from the handle and rinse the

brush head connection with warm water at least once

a week. Rinse the brush head cap as often as needed.

1 Unplug the charger before you clean it.

2 Wipe the surface of the charger with a damp cloth.

Rinse with warm water and use a damp cloth to clean

inside of travel case.

1 Unplug the charging travel case before cleaning.

2 Use damp cloth to wipe the surface of the travel case.