Télécharger Imprimer la page

ROYAL GOURMET PD1302S-F Mode D'emploi page 7

Publicité

Operating Instructions
Each griddle burner is tested and calibrated at the factory prior to shipment; however, variations in the local gas
supply may make it necessary to adjust the burners. Please visually check the flames of the burners. Always
visually inspect your griddle before lighting. Replace any hose that is frayed or cracked. Look for anything that
could block ventilation and remove such a blockage or move the griddle. After lighting, check the flame pattern
to ensure you have even heat distribution for each burner. If burners don't light up, or if the flame pattern is uneven,
see the Troubleshooting section.
1. Read the instructions before lighting.
2. If the burner does not ignite in 5 seconds, turn the burner control knob(s) off, wait 5 minutes and repeat the
lighting procedure.
3. Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the griddle if the odor of gas is present.
4. Never use regulators and hose assemblies other than those supplied with the griddle. If a replacement is
necessary, contact the manufacturer to get the proper replacement. The replacement must be as per the
specifications in the Owner's Manual. DO NOT LEAVE THE GRIDDLE UNATTENDED WHILE COOKING.
LIGHTING INSTRUCTIONS:
1. Turn all the control knobs clockwise to the "OFF" position.
2. Connect the regulator to the gas tank. Turn on the gas supply at the
regulator or at the gas tank valve.
3. Push the control knob and keep pressing while turning anticlockwise
to the high "Fire" position. Push the igniter button rapidly.
4. If the burner does not ignite within 5 seconds, turn the control knob off,
wait 5 minutes, and repeat step 3.
5. Repeat step 3 to 4 for other burners.
* Should the burner still fail to ignite, check the gas supply.
lgniter
TURNING OFF YOUR GRIDDLE
1. Turn off the gas supply at the gas cylinder by turning the valve clockwise to a full stop.
2. Turn all burner control knobs to OFF position.
!
WARNING:
BEFORE LIGHTING
7
!

Publicité

loading