Publicité
GAS CYLINDER LEAK TEST
1. Leak test must be repeated each time the gas cylinder is exchanged or refilled.
2. DO NOT smoke or have anything nearby that can easily ignite, such as lighters or matches.
3. DO NOT use an open flame to check for gas leaks.
4. The appliance must be leak checked outdoors in a well-ventilated area away from open flames or sparks.
5. REMOVE any pots or other cookware from the burner before beginning the test.
STEPS FOR LEAK TEST:
Use a clean paint brush and 50/50 soap and water solution.
NOTE: Use a mild soap and water. DO NOT use household cleaning agents, which could damage the gas
component.
1. Turn all burner control knobs, regulator and cylinder valves OFF.
2. Be sure regulator is tightly connected to gas cylinder.
3. Completely open gas cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn
gas off immediately. There is a major leak at the connection. Correct before proceeding.
4. Brush the soapy solution onto all metal seams and the entire valve area.
5. Slowly turn the gas cylinder valve counterclockwise to the open position.
6. A leak is identified by a flow of bubbles from the area of the leak. Close gas cylinder valve immediately and
retighten connections.
7. If leaks cannot be stopped, do not try to repair, contact your gas griddle dealer for assistance. Do not attempt
to operate appliance if a leak is present.
8. Always examine the hose for any damage. If damage is observed, do not attempt to patch the hose.
Replacing the hose is the only safe option.
9. For assistance with any malfunction related to the gas cylinder, regulator or hose, contact customer service.
10. Always close gas cylinder valve after performing leak test by turning hand wheel clockwise.
UNDER NO CIRCUMSTANCE SHOULD THE VALVE REMAIN IN THE ON POSITION FOR MORE THAN
12 SECONDS.
1. DO NOT USE THE GRIDDLE if there are leaks. Be sure the gas cylinder valve is closed. If the gas cylinder
is still leaking, contact your gas dealer.
2. Do not use any matches, open flames, or smoke during leak testing.
3. Do not light any burners during leak testing.
4. Replacement parts, including a replacement hose assembly, must be as per the specifications in the parts list.
Failure to comply with these instructions may result in serious bodily injury.
!
WARNING
6
!
Publicité
