Publicité
camera, push one end of the strap through the two brackets on
the back of the camera. Thread the end of the strap through the
buckle. Fasten the strap securely around the tree trunk by
pulling the end of the strap firmly so there is no slack left
(Figure 8).
Using the tripod socket: The camera is equipped with a
socket at the bottom end to enable mounting on a tripod or
other mounting accessories with a standard UNC 1/4-20 thread
screw (not included).
9.2. SENSING ANGLE AND DISTANCE TEST
To test whether the camera can effectively monitor the area
you choose, this test is recommended to check the sensing
angle and monitoring distance of the camera. To perform the
test:
Switch the camera to the ON mode.
Press MENU button, go to "Motion Test". The camera will
count down a max 60-second delay and be ready to capture
motions. (Note: The delay time may be less than 60 seconds,
depending on the actual time of the motion sensor to be
activated. The delay time is 60 seconds minus the power-on
time.)
Figure 8: Mounting the Camera
17
Publicité
