Epson EB-595Wi Guide D'installation page 62

Installation Guide
l
Trace the dots (
When angle adjustment is performed correctly, the dots you have traced disappear.
c
Touch operations may not perform correctly if you are wearing artificial nails or nail polish, or
if your fingers are obstructed by bandages and so on.
When all of the dots have disappeared, press the [
step 14.
If some dots remain as shown in the following figure, check the following points.
• Remove any obstacles that are around the projection screen. After removing any obstacles, press the [
[ ] button on the remote control, and then perform step 12 again.
• If the dots still remain after removing obstacles, turn the adjustment dials about a quarter turn
counterclockwise. Next, press the [
again.
• Go to step 13 if dots still remain even after performing this step, or there are obstacles that cannot be removed
such as whiteboard trays or frames.
) with your finger
] or [
] button on the remote control, and then go to
] button on the remote control, and then perform step 12
60
] or