Publicité
4. Install fasteners – Feed coiled end of pull wire through rearmost mounting hole bottom of frame and out of Access Hole, both sides. Attach ½" carriage bolts and ¼"
spacer blocks to pull wires and pull the fasteners into position. Leave pull wires attached. Repeat process for forward attachment holes. See Figure 1.
5. Install hitch – Raise hitch into position and feed the pull wires through mounting holes in hitch. With bolts and hitch in position, remove pull wires and loosely install
the conical washers and hex nuts onto carriage bolts, (4) places (2 per side). Torque fasteners to specifications below.
6. Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. ( 102 N*M)
7. Reinstall Underbody Panel – Using factory fasteners, reinstall the trimmed underbody panel removed in Step 1.
©2024 Horizon Global Corporation- Printed in México
Proper torque is needed to keep the hitch secure to the vehicle when towing.
For additional security, thread locker can be used on all fasteners.
Sheet 8 of 24
76656NP
9-10-24
Rev. A
Publicité
