Publicité
2. Enlarge Access Hole - Using die grinder with rotary tool bit, enlarge Access Hole enough to fit head of carriage bolt and block, both sides. Paint enlarged hole area to
protect against corrosion. See Figure 1.
3. Trim Underbody Panel - using a tape measure, painter's tape, marker, and utility knife, measure, mark, and cut a notch in rearward center of Underbody Panel, 3 ½ '
wide by 6", See Figure 2. DO NOT trim bumper fascia.
3 ½"
Area to Trim
6"
L C
of Vehicle
Underbody Panel
©2024 Horizon Global Corporation- Printed in México
Sheet 7 of 24
76656NP
9-10-24
Rev. A
Publicité
