Publicité
Always wear SAFETY GLASSES
when installing hitch
(a)
(b)
1. Remove the Underbody panel.
a) Using a 7mm socket, remove (14) screws from underbody panel.
b) Using a T15 torx bit, remove (4) screw from underbody panel (4 each side).
c)
Using a flat screwdriver, remove (1) push-pin near of the wheel (1 each side).
d) Using a flat screwdriver, remove (1) push-pin from bottom area of the fascia (1 each side).
e) Apply painter's tape around rear Bumper Fascia seams to protect the paint.
f)
Underbody panel, carefully remove the underbody panel pulling downwards.
©2024 Horizon Global Corporation. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76656, 84656, CQT76656
(c)
(a)
(d)
Sheet 3 of 24
(f)
76656NP
9-10-24
Rev. A
Publicité
