Hilti TE 1000-AVR Mode D'emploi Original page 9

3.2 Intended use
The product described is an electrically powered breaker for heavy chiseling work.
It is designed for breaking or demolishing concrete, masonry, stone and asphalt.
▶ Operation is permissible only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.3 Possible misuse
This product is not suitable for working on hazardous materials.
This product is not suitable for working in a damp environment.
3.4 Active Vibration Reduction (AVR)
The breaker is equipped with an Active Vibration Reduction (AVR) system, which reduces vibration
significantly.
3.5 Power level indicator
The breaker is equipped with a power level indicator LED.
Chiseling power can be reduced to approx. 70% by pressing the power level selector switch. The power
level LED then lights up, indicating reduced power.
3.6 Service indicator information
The breaker is equipped with a service indicator LED.
Status
The service indicator lights red.
The service indicator blinks red.
Bring the product to Hilti Service in good time. This will help to ensure that it's always ready for use.
3.7 Items supplied
Breaker, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Breaker
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Product generation
Weight in accordance with EPTA procedure 01
Single impact energy in accordance with EPTA
procedure 05
*2190682*
Meaning
End of service interval – servicing is due.
A fault has occurred in the tool.
The overheating prevention cut-out has been acti-
vated.
The voltage provided by the electric supply is too
high.
TE 1000­AVR
02
12.5 kg
26 J
2190682 English 5