Hilti TE 1000-AVR Mode D'emploi Original page 8

▶ Use a dust removal system and suitable mobile dust extractor whenever possible. Dust from materials
such as lead-based paint, certain types of wood and concrete/masonry/stone containing quartz, minerals
or metal can be harmful to health.
▶ Make sure that the workplace is well ventilated and, where necessary, wear a dust mask appropriate for
the type of dust generated. Contact with or inhalation of the dust may cause allergic reactions and/or
respiratory or other diseases to the operator or bystanders. Certain kinds of dust, such as oak and beech
dust, are classified as carcinogenic, especially in conjunction with additives for treating wood (chromate,
wood preservative). Only specialists are permitted to handle material containing asbestos.
▶ Approval must be obtained from the site engineer or architect prior to beginning the work. Work on
buildings and other structures may influence the statics of the structure, especially when steel reinforcing
bars or load-bearing components are cut through.
Electrical safety
▶ Before beginning work, check the working area for concealed electric cables or gas and water pipes.
External metal parts of the power tool may give you an electric shock if you damage an electric cable
accidentally.
▶ Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged. If the power tool's supply cord is damaged it must be replaced with a specially-
prepared and approved supply cord available from Hilti Customer Service. Check extension cords at
regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension
cord if it is damaged while working. Disconnect the supply cord plug from the power outlet. Damaged
supply cords or extension cords present a risk of electric shock.
▶ Dirty or dusty power tools that have been used frequently for work on conductive materials should be
checked at regular intervals at a Hilti Service Center. Dust (especially dust from conductive materials) or
dampness adhering to the surface of the power tool may, under unfavorable conditions, lead to electric
shock.
▶ Switch the power tool off and unplug the supply cord in the event of a power failure or interruption in the
electric supply. This will prevent accidental restarting when the electric power returns.
3 Description
3.1 Product overview
4 English
1
Chuck
@
Air vents
;
Side handle
=
Knob
%
On/off switch
&
Grip
(
Power level selector switch
)
Connector on electric tool
+
Supply cord with keyed, releasable plug con-
§
nector
Service indicator
/
Power level indicator
:
2190682
*2190682*