Power Fist 8893547 Mode D'emploi page 6

8893547
11. Check the fasteners and components of the chipper before each operation,
ensuring they are as required.
12. Do not tamper with governor spring, links or other engine parts to
increase speed or power.
13. The engine and exhaust become very hot during operation. Severe thermal
burns can occur on contact, especially with the muffler.
a. Remove accumulated debris from muffler and cylinder area.
Combustible debris, such as leaves, grass, brush, etc. can catch fire if
they come in contact with a hot engine.
b. Do not place anything on the engine while it is running.
c. Allow muffler, engine cylinder and all other components to cool
before touching.
14. Do not operate the engine with the air cleaner or the carburetor air intake
cover removed.
FUEL SAFETY
DANGER! Fuel is very flammable. Use extreme care when handling or storing
fuel. An ignition source contacting the fumes or fuel may result in a fire or
explosion and cause fatal or serious injuries to you or a bystander.
WARNING! Always shut the engine off and allow to cool before fuelling. Never
add fuel to a machine with a running or hot engine. Move at least 10 ft. from the
refuelling site before starting the engine to avoid an explosion or fire.
1. Use only an approved fuel container for storing and refueling.
2. Do not allow open flames, sparks or smoking near fuel.
3. Fuel cans may be under pressure due to temperature. Loosen fuel caps
slowly, allowing the pressure to equilibrate.
4. Do not fill fuel tanks indoor. Always fill fuel tanks outdoors over bare
ground.
5. Inspect for fuel leaks. Do not start until leakage is repaired.
6. Store fuel out of direct sunlight in a cool and dry location.
7. Wipe up any spilled fuel before starting the engine or allow to evaporate.
Spilled fuel is both a fire hazard and an environmental hazard. Dispose of
the fuel soaked rags in a proper hazardous waste container.
6
420cc Gas Wood Chipper
For technical questions call 1-800-665-8685
V1.0