Power Fist 8893547 Mode D'emploi page 4

8893547
WORK AREA
1. Operate in a safe work environment. Keep your work area clean, well-lit
and free of distractions. Place lights so you are not working in a shadow.
2. Keep children, animals or untrained and unprotected people at least 50 ft
from the working area.
3. Store tools properly in a safe and dry location. Keep tools out of the reach
of children.
4. Do not install or use in the presence of flammable gases, dust or liquids.
5. Operate only on level, firm ground. Never operate on slippery, uneven, icy
or wet surfaces.
6. Do not operate in exceptionally windy conditions. Always position the tool
and discharge chute in a manner that debris is delivered away from
people, roads and other hazards.
7. Do not operate in a confined or indoor spaces without proper ventilation.
8. Operate only in daylight or in well-lit conditions.
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the Canadian
Standards Association (CSA) or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
1. Always wear impact safety goggles that provide front and side protection
for the eyes. Eye protection equipment should comply with CSA Z94.3-07
or ANSI Z87.1 standards based on the type of work performed.
2. Wear the appropriate type of full-face shield in addition to safety googles,
as the work can create chips, abrasive or particulate matter.
3. Wear gloves that provide protection based on the work materials or to
reduce the effects of tool vibration.
a. Do not wear gloves when operating a tool that can snag the material
and pull the hand into the tool.
4. Wear protective clothing designed for the work environment and tool.
5. Non-skid footwear is recommended to maintain footing and balance in the
work environment.
6. Wear steel toe footwear or steel toe caps to prevent a foot injury from
falling objects.
7. Wear the appropriate rated dust mask or respirator.
4
420cc Gas Wood Chipper
For technical questions call 1-800-665-8685
V1.0