Power Fist 8893547 Mode D'emploi page 10

8893547
10. Securely hold the wood workpiece
to be chipped.
11. Standing off to the si de (Fig. 1-1), feed the
workpiece into the infeed chute.
12. If wood becomes lodged during operation.
Turn off the engine and disconnect the spark
plug wire and battery terminals before
attempting to inspect or dislodge.
13. Once operation is complete, always ensure to turn the chipper off by
accomplishing the following:
a. move the throttle to the IDLE position.
b. If using recoil start, turn the ignition switch to the OFF position.
c. If using electric start, turn the key to the OFF position.
CARE & MAINTENANCE
WARNING! Before performing any inspections or maintenance, turn off the
engine, allow it to cool for at least 5 minutes and then disconnect the spark
plug wire, keeping it away from the spark plug and battery terminals.
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
10
420cc Gas Wood Chipper
For technical questions call 1-800-665-8685
V1.0
Fig. 1