Publicité
1.2. INSTALLATION
01
Unclip the front plate by pressing the spring clips on the side.
Check for a control module! Remove the casing and
disconnect the control module.
03
Install the condensate drain.The condensate drain system
should be fitted with a siphon to prevent odours. The siphon
can be either on the unit or on the final condensate connection
(downstream from the condensate trap). Pour water into the
condensate trap and check that it drains normally. If not, check
the drain angle.
If the unit is used for cooling, the hydronic pipes must be insulated.
When using devices for cooling: iron couplings prohibited.
05
see 3. Electrical connection
60
02
Mark and drill the mounting holes. Install the unit with the
supplied mounting material.
Use plugs that are suitable for the type of wall.
04
Connect the unit to the hydronic system by using the indicated
inlet/outlet connections. Make sure the connections are airtight -
use a sealant. The heat exchanger comes with a supplied air vent
and sealing plug.
06
Place the front plate and click into place with the spring clips.
JAGA NV | BRIZA XS - ON/OFF | MANUEL | 26.09.2024 | V.1.05
Use a back wrench
when fastening the
hydronic connections!
CLICK
Publicité
