Publicité
While the shaft lock is pressed solve with an Allen wrench by turning the
screw counterclockwise
Remove the allen screw, washer and the outer blade flange
Pay attention that the inner flange remains on the shaft.
Pull the blade guard back cover Fig. P
Remove the blade.
During installation, these steps are run in reverse.
Caution:
However, make use of the direction of the saw blade in!
14.2
Cleaning
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therfore:
When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate (with anti-rust WD40 )
14.3
Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
15
TROUBLESHOOTING
Disconnect the machine from the power supply prior to any checks performed at the machine
itself!
Trouble
Machine does not start
Blade does not come up to
speed
Machine vibrates strongly
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Fig. O
N O T E
Possible cause
• Machine is not connected
• Blown fuse or contactor
• cable loose
• cable is damaged
• Extension cord too long
• Engine is not suitable for
existing power
• weak power grid
• Standing on uneven ground
• Motor mount is loose
• unbalanced blade
TROUBLESHOOTING
Fig. O
Fig. P
Solution
• Check all electric
connections
• Change fuse, activate the
contactor
• Check cable
• replace cable
• Exchange on optional
extension cable
• see the wiring box cover for
correct wiring
• Contact the electrician
• New Setup
• Tighten the fixing screws
• Check cause - fix.
22
MKS180_230V
Publicité
