Publicité
Fig. I
Place the workpiece on the rear back stop.
Clamp the workpiece firmly by turning the handwheel (11) clockwise.
13.2.4
Setting the miter angle
Loosen the clamping knob (8) by turning counterclockwise Figure K.
Turn the back stop (2) to the desired angle. This can be read on the scale.
Fig. K
Pull the cocking handle (8) by turning it clockwise again.
The front jaw pivots automatically in the intended position.
13.2.5
Setting the depth stop
Loosen the hex nut with a wrench 13th With an Allen wrench 8, you can set the appropriate depth.
Fig. L.
Tighten the hex nut.
Fig. L
13.2.6
Cutting
Turn on the machine
Wait until the metal blade at full speed is.
Pull the saw head down gently and cut the material slowly.
Pull the saw head back to the starting position. Turn off the machine.
CAUTION:
Check before cutting that the workpiece is tightened in a vice.
Use coolant when cutting !
Otherwise, the life of the saw blade reduces.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Fig. J
N O T E
OPERATION
20
MKS180_230V
Publicité
