Publicité
In-ro2zm
Installation Guide
/\, WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not con-
tain warnings or cautions of potential dangers in attempting to
install this product.
Any attempt to install this product in a motor vehicle by anyone
other than qualified installer could cause damage to the electrical
system and could result in serious personal injury or death.
L] Overview
This equipment should be installed by a profession-
al. However, if you plan to install this unit yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to "WARNING"
statement above).
è Identify and label the vehicle wires
e Connect the vehicle wires to the wires of the
power connector
è Install the unit in the dash
e Check the operation of the unit
If you do encounter problems, please consult your
nearest professional installer.
CAUTION:
This unit will operate with a 12 volt OC
negative ground auto battery system only. Do not
attempt to use it in any other systems. Doing so
could cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
è Warranty Card ...... Fill this out promptly
+ Panasonic Servicenter for service Directory
eee
Keep this for future reference in case the
unit needs servicing
è Installation Hardware ...... Needed for in-dash
installation
CQ-FX35EUC
Q installation Hardware
pof
tem [Diagram | Gy
© | Hex. Nut (5 mmo)
Rear Support Strap
Tapping Screw
(5 mmo x 16 mm)
Mounting Bolt (5 mmo)
B
OSs
AX AON
Power Connector
©
Removable Face Plate
ase
Remote Control Unit
Trim Plate
©
Leererslerens
|i
Lithium battery
Publicité
