Publicité
v.
DO NOT allow sanding sheets to wear
away on the sanding pad. This will
damage the surface of the pad requir-
ing replacement and may cause parts
of the sanding sheet to fly off the pad,
causing operator injury.
w. DO NOT touch the moving sanding
sheet.
x. Wire brush bristles are thrown by the
brush even during ordinary operation.
DO NOT overstress the wires by apply-
ing excessive load to the brush. The
wire bristles can easily penetrate light
clothing and skin.
Note: The tool must ONLY be used for its
intended purpose. Any use other than those
mentioned in this manual will be considered
a case of misuse. The operator, and not the
manufacturer, shall be liable for any dam-
age or injury resulting from such cases of
misuse. The manufacturer shall not be
liable for any modifications made to the
tool, nor for any damage resulting from
such modifications.
4. Before first use
Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!
5. Intended Use
Oscillating multi-function tool with quick
accessory-change mechanism, designed
for cutting and abrasive tasks by fast oscil-
lation of a blade, file or sanding pad.
7064717-300W-AVS-Multitool-Ma-2403-11.indb 9
7064717-300W-AVS-Multitool-Ma-2403-11.indb 9
6. Preparing the Tool for Use
Fitting a Blade or Scraper
6.1
a. Lift the quick release (2) and push for-
ward to disengage the clamping
mechanism.
Note: This requires some strength.
b. Fit a compatible blade or accessory to
the accessory mounting (9).
c.
Ensure the correct orientation of the
blade or accessory on the accessory
mounting so it faces the required
direction.
d. Secure the blade or accessory with the
quick release bolt (7) and return the
quick release to the closed position.
Note: Blades or scrapers that are cranked
or bent must be mounted on the tool so that
the end of the blade sits facing away from
the machine.
Fitting a Sanding Pad and Sanding
6.2
Sheet
a. Fit the hook and loop sanding pad by
following the instructions under 'Fitting
a blade or scraper'.
b. Select the required sanding sheet for
your intended task (see 'Selecting the
right grade of sanding sheet').
c.
The sanding pad and sanding sheets
use a hook and loop system for attach-
ment. Carefully line up one corner of the
sheet with a corner of the sanding pad
and gradually push the rest of the sheet
on to the pad, checking the alignment
until the sheet is fitted correct-ly.
Selecting the right Grade of Sanding
6.3
Sheet
• Sanding sheets are available in a variety
of different grades: coarse (60 grit),
medium (120 grit) and fine (240 grit).
• Use a coarse grit to sand down rough
finishes, medium grit to smooth the
work, and fine grit to finish off.
• Always use good quality sanding sheets
to maximise the quality of the finished
task.
• It is advisable to do a trial run on a
scrap piece of material to determine the
optimum grades of sandpaper for a
particular job. If there are still marks on
English
9
12/03/2024 13:22
12/03/2024 13:22
Publicité
