Publicité
EN
Replacing The Light Bulb
1. Make sure the range hood is powered off.
2. Remove the filter, squeeze the clips on both sides of the LED light from inside the
range hood and push the LED light down to separate it from the ring hole
board, as shown below.
3. For some models, you can't reach the top of the light bulb without removing certain
components. You can gently pry out the frame of the round LED light with a flathead
screwdriver as shown in figure below.
4. Unplug the wire connector and reconnect the new LED light.
5. Push the new LED light back into the round hole to install it in place.
6. Restore power to the range hood and test the LED light.
24
Enjoy Every Cooking | Belgrade 36SS
of the light
www. v esta.kitchen
Publicité
