Publicité
The product must only be installed by qualified persons, according to the local safety standards and
regulations. Fracarro Radioindustrie is free from all civil and criminal responsibilities due to breaches of the
current legislation derived from the improper use of the product by the installer, user or third parties. The
product must be used in full compliance with the instructions given in this manual in order to protect the
operator against all possible injuries and the product from being damaged.
Do not open the product container, dangerous voltage parts can be accessible when opening the packaging.
Installation warnings
●
The product must not be exposed to any dripping or splashing and thus it should be installed indoors
and in a dry location.
●
Humidity and condensation could damage the product. In case of condensation, wait until the product
is dry before using it.
Handle the product carefully. Impacts can damage the product.
●
Leave enough space around the product to ensure sufficient ventilation.
●
Excessive temperatures and/or an overheating may affect the performance and the life of the product.
●
Don't install the product above or near any heat sources, in dusty places or where it might come into
●
contact with corrosive substances.
In the event that the unit is fixed to the wall, use the proper screw anchors suitable to the
●
characteristics of the fixing support. The wall and the anchoring system must be able to support at
least 4 times the weight of the unit.
Attention: to avoid being hurt, the unit must be fixed to the wall/floor in accordance with the installation
●
instructions.
For "PERMANENTLY INSTALLED APPLIANCES", an easily accessible cutting device must be added to
●
the exterior of the appliance; for "APPLIANCES WITH A POWER PLUG", the socket must be installed
close to the appliance and easily accessible.
The product must be connected to the earth electrode of the antenna system, in accordance with
●
standard EN60728-11. The screw arranged for this scope is marked by the symbol
It is recommended to comply with the provisions of the standard EN60728-11 and to connect this
●
screw to the main earth node of the plant (do not connect to intermediate points).
Earth symbol of the antenna system
General warnings
In the event of a malfunctioning, do not try to fix the product as the guarantee would be invalidated.
Use only the power adapter supplied with the product.
Although the information given in this manual has been prepared carefully and thoughtfully, Fracarro
Radioindustrie S.r.l. reserves the right to modify it without notice and to improve and/or modify the product
described in this manual. See the website
support and product guarantee.
SAFETY WARNING
www.fracarro.com
to have information relevant to the technical
8
Publicité
