Troubleshooting Guide - Inverter - Wagan Tech Power Dome EX Guide D'utilisation

Power Dome® EX by Wagan Tech

TROUBLESHOOTING GUIDE - INVERTER

Trouble
Lack of power output
Inverter Power Indicator
is not lit.
Television/Power
Tool will not start
Television Interference
Static/noise interference
in audio system
14
Cause
Power Dome® EX battery
voltage below 10 volts
Excessive current drawn
by appliance being
operated
Inverter fuse blown
Excessive voltage drop
Inverter is overloaded
High surge wattage
requirement to start-up
Picture breaking up
(static)
Sound system has weak
alternating current
shielding.
www.wagan.com
Remedy
Recharge the Power Dome® EX immediately.
Reduce load to maximum of 400 watts.
1. Turn off the device and inverter.
2. Disconnect device.
3. Turn the inverter on and leave run-
ning for a minimum of 2 minutes.
4. Turn off inverter.
5. Quickly plug in device to inverter.
6. Turn on the inverter and the device.
Check and replace if
necessary. Be sure replacement fuse is the
same type and rating.
Check Power Dome® EX and recharge if voltage
drops below 10 volts.
Reduce load to maximum of 400 watts.
Toggle the Inverter Power Switch on and off in
quick succession a total of 5 times. If the device
does not start, the device is not compatible with
this type of inverter.
Place the Power Dome® EX as far as possible
from the TV, the antenna, and the coaxial cable.
TV station may be out of range.
Do not use inverter with low quality audio AC
filtering system.
Replace audio system with high quality noise
filtering.