Power Inverter - Wagan Tech Power Dome Plex Guide D'utilisation

2. Open the compartment door at the rear of the Power Dome and extend the air hose.
3. Position the Power Dome so that you can see the pressure gauge.
4. Make sure the chuck lever is positioned up (away from the chuck opening).
5. Determine if you will need an air hose adapter for your object.
• To inflate a vehicle tire:
a. Remove the valve cap from the valve stem of the tire.
b. Attach the chuck of the air hose to the tire's valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.
• To inflate a sports equipment, air mattress, rafts, or other plastic inflatables:
a. Insert the proper valve stem adapter into stem connector as far as possible.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable's air valve opening
as far as possible.
6. Set the Air Compressor Switch on to the "I" position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When recommended tire pressure has been reached, turn off the air compressor.
9. Disconnect the hose and replace valve cap.
10. Return the hose back to its compartment for storage.
11. Recharge the Power Dome as soon as it is convenient.

POWER INVERTER

The Power Dome Plex can run most AC appliances or a combination of appliances up to 400
®
watts. Operating time is dependant on the AC load (required wattage) and the current charge/
condition of the Power Dome's internal battery. Reduced AC loads and/or having a full charge on
the internal battery will result in longer operating time. Ordinary overloads will cause the inverter
to automatically shut down. Reduce the load and restart the inverter.
There is a user-replaceable automotive-type fuse protecting the inverter from an unlikely excessive
power draw or short circuit. REPLACE ONLY WITH THE SAME TYPE AND RATING FUSE. To
replace the fuse, simply pull it out with a pair of needle nose pliers and insert the new fuse.
Caution
Some rechargeable devices are equipped with a separate AC charger. These devices are
likely to operate properly with the inverter in this unit. Rechargeable devices that have built-in
chargers (see your device's user manual) may not operate properly with this unit because the
inverter is modified sine wave.
Some motorized devices may operate at excessively elevated temperature when used with this
inverter. During first use with this inverter, check for excessive motor temperature. Abnormally
elevated temperature of the device is an indication that they should not be used together.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2018 Wagan Corporation. All Rights Reserved.
13