Troubleshooting - Wagan Tech IONBoost V10 Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

iOnBoost™ V10 by Wagan Tech

7. Securely connect the positive (+) red clamp to the positive (POS, P, +) terminal of the vehicle

battery or the remote positive (+) terminal if equipped.

8. Securely connect the negative (−) black clamp to a non-moving, metal part of the engine or

frame as far away from the vehicle battery as possible.

9. Turn jumpstarter power switch to the

10. When the clamps are properly connected to the battery, the status light will illuminate a

steady red. It may take a few seconds after connection for the red light to illuminate. When

the light illuminates steady red, it is safe to proceed in these instructions. If the status light

fails to illuminate steady red, consult the troubleshooting section of this manual.

11. Place unit on a secure surface away from moving parts.

12. Start vehicle engine. Stop if the vehicle does not start after 3 to 4 seconds of engine

cranking. Wait 3 to 4 minutes, then try again. If engine does not start after second attempt,

discontinue cranking and consult a professional.

13. When finished, switch the jumpstart power switch to the " " position. Disconnect the clamps

in reverse sequence of connecting procedure—first disconnect negative (black), then positive

(red) clamps. Do not let the clamps touch each other.

14. When convenient, using either AC or DC charging adapter, completely charge the

iOnBoost battery.

15. Store the unit and charge adapters in a cool, dry environment, away from flammable

materials. Remember to fully charge the unit every three months.