Jumpstarting; Work Light - Wagan Tech Power Dome EX Guide D'utilisation

Masquer les pouces Voir aussi pour Power Dome EX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

i.
Connect negative (−) black clamp to vehicle battery's negative terminal.
ii.
Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal ve-
hicle component or body part. DO NOT clamp directly to positive battery terminal
or moving part.

JUMPSTARTING

1.
Review the Jump Start Warnings.
2.
Make sure all vehicle appliances, lights, radio, etc are turned off.
3.
Make sure the vehicle's gear is in "park" position and the brake is set.
4.
Make sure all Power Dome
5.
Securely connect the red (+) cable clamp to the vehicle's positive (+) battery terminal.
6.
Connect the black (−) cable clamp to a non-moving part on the vehicle.
7.
Observe the color of the Reverse Polarity Protection Indicator that is located between the
Battery Status button and Work Light switch.
If the light is RED, DO NOT TURN ON THE JUMPER SAFETY SWITCH!
1.
Cable clamps need to be reversed.
2.
Disconnect the black clamp first then the red clamp.
3.
Reconnect and observe the indicator again.
If the light is GREEN, turn on the Jumper Safety Switch.
1.
Inside the vehicle, turn on the ignition switch and attempt to start the engine.
2.
Crank a maximum of three seconds. If the engine does not start, wait three
minutes before the next attempt.
3.
After the engine starts, turn off the Jumper Safety Switch.
4.
Disconnect the black clamp first, and then disconnect the red clamp.
8.
Be sure that the cables and clamps are securely stored.
9.
Recharge the Power Dome
NOTE: If the engine does not start, there may be a problem other than a discharged battery. Call
for service.

WORK LIGHT

The Work Light is a cluster of bright LEDs located above the negative Jumper Cable storage area.
The location of the Work Light allows the light to be used while the Power Dome
carried.
Turn the work light switch (located on front panel) to the "I" position for power on.
The light will illuminate.
Turn off while not in use.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
EX switches are off.
®
EX as soon as convenient.
®
©2013 Wagan Corporation. All Rights Reserved.
EX is being
®
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2454

Table des Matières