Publicité
SF 0440
Component pack, including:
- Bolts
- Wing nuts
- Bolt plate
- Cover
2. Assemble fan head
Remove the grill nut and blade knob from the motor assembly, note that the
blade knob is reverse threaded. Turn clockwise to remove from the motor
shaft.
Place the rear grill over the motor shaft and onto the motor. Assembly
nothing that the handle should be positioned toward the top of the fan. The
small plastic pin of the motor assembly should be aligned with the hole in
the rear grill. Reattach the grill nut, turning clockwise to secure the rear
grill to the motor assembly.
Align the motor shaft with the "D" shaped hole of the fan blade. Fully insert
the motor shaft into the fan blade, then secure
with the blade knob, turning counter-clockwise. Do
not overtighten.
Place the front grille facing the rear and joins
with the locking ring. Tighten the screw ring so
that the grid is firmly united.
3. Base assembly
1.
Forms a cross with the base and insert the tube
through the center of the cross and secure with
the nut.
2.
Lengthen the tube and join with the motor body.
Tighten the screw to secure the union.
4. Final assembly
Twist the thumb screw at the bottom of the motor
assembly counter-clockwise until no threaded
portion is visible within.
Place the chrome end of the pole assembly within
the hole at the bottom of the motor assembly and
fully insert. If the pole will not fully insert,
the thumb screw must be further loosened. Twist the
thumb screw clockwise to tighten the motor assembly
to the pole and fan assembly is now complete.
OPERATION
Place the assembled fan on a flat, level, firm and dry surface.
Plug the power cord into a polarized 230 volt AC wall outlet.
Turn the fan on and select the desired running speed with the speed control
(0 – off; 1 – low; 2 – medium; 3 – high) switch conveniently and safely
located at the front of the fan below the front grill.
To adjust the fan‟s height, loosen the height adjustment knob by unscrewing
counter clockwise only a few turns. Pull upward on the chrome portion of the
base assembly while holding the lower portion firmly to raise the height, or
push down on the chrome portion to lower. Retighten the height adjustment
knob, being careful not to overtighten.
To adjust the normal upward or downward tilt of the fan head, loosen the tilt
knob on the side of the motor assembly and carefully lift or lower the head
10
Publicité
