Publicité
PREVENTION OF BLOOMING AND
SMEAR
When the camera is aimed towards spotlights or other
bright lights or light reflecting objects, smear or bloom-
ing may appear. Therefore the camera should be oper-
ated carefully in the vicinity of extremely bright objects
to avoid smear or blooming.
If the camera is aimed at the sun or very bright light,
such as laser beam, for a long period of time, the CCD
image sensor may be burned in and blemishes (white
or black dots) appears on the picture.
SPECIFICATIONS
Pick-up Device :
Scanning System :
Scanning :
Horizontal :
Vertical :
Horizontal Resolution :
Video Output :
Signal to Noise Ratio :
Electronic Light Control :
Minimum Illumination :
White Balance :
Back-Light Compensation :
Sync System :
Aperture :
AGC :
Ambient Operating Temperature :
Power Source :
Dimensions (excluding lens) :
Weight (excluding lens) :
Weights and dimensions indicated are approximate.
Specifications are subject to change without notice.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Smear
Bright object
-11-
752(H) x 582(V) pixels, 1/2" Interline Transfer CCD
2 : 1 Interlace
625 Lines / 50 Fields / 25 Frames
15,625 kHz
50 Hz
480 lines
1.0 Vp-p PAL composite, 75 ohms/BNC connector
50 dB (AGC OFF)
Equivalent to continuous variable shutter speed between 1/50 sec. and
1/15,600 sec.
3 lux (0.3 footcandle) at F 1.4 (AGC ON)
AWC / ATW selectable
Selectable On/Off
Internal
Selectable Soft/Sharp
Selectable On/Off
−10° C - +50° C (14° F - +122° F)
10.8 - 16 V DC, 300mA
67(W) X 55(H) X 123(D) mm
2-5/8"(W) X 2-3/16"(H) X 4-13/16"(D)
460g (1.0 lbs.)
-12-
Publicité
