Publicité
V1.1
5.
Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a.
Position power cords away from traffic areas.
b.
Place cords in reinforced conduits.
c.
Place planks on either side of the power cord to create a protective
trench.
6
Do not wrap cord around tool, as sharp edges may cut insulation or cause
cracks if wound too tight. Gently coil cord and either hang on a hook or
fasten with a device to keep cord together during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
Contents:
• Welding Unit
• MIG Gun with Cable
• Ground Cable with Clamp
Visit www.princessauto.com for more information
90A Flux Core Welder
• 0.030 contact tip
• Brush/Chipping Hammer
• Hand-held face shield
9195264
11
Publicité
