Publicité
State of abnormality
The vacuum cleaner does not run
along with the switch operation of
the tool.
The vacuum cleaner runs while the
tool is not operating.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
CAUTION:
Clean out the upper and lower
blade guards to ensure there is no accumulated
sawdust which may impede the operation of the
lower blade guarding system. A dirty guarding sys-
tem may limit the proper operation which could result
in serious personal injury. The most effective way to
accomplish this cleaning is with compressed air. If
the dust is being blown out of the blade guards,
be sure the proper eye and breathing protection
is used.
CAUTION:
After each use, wipe off the saw
dust on the tool. Fine saw dust may come inside the
tool and cause malfunction or a fire.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Probable cause (malfunction)
The wireless unit is not installed into
the tool.
The wireless unit is improperly installed
into the tool.
The terminal of the wireless unit and/or
the slot is dirty.
The wireless activation button on the
tool has not been pushed.
The stand-by switch on the vacuum
cleaner is not set to "AUTO".
More than 10 tools are registered to the
vacuum cleaner.
The vacuum cleaner erased all tool
registrations.
No power supply
The tool and vacuum cleaner are away
from each other (out of the transmission
range).
Radio disturbance by other appliances
which generate high-intensity radio
waves.
Other users are using the wireless
activation of the vacuum cleaner with
their tools.
19 ENGLISH
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
Push the wireless activation button briefly and make
sure that the wireless activation lamp is blinking
in blue.
Set the stand-by switch on the vacuum cleaner to
"AUTO".
Perform the tool registration again.
If more than 10 tools are registered to the vacuum
cleaner, the tool registered earliest will be cancelled
automatically.
Perform the tool registration again.
Supply the power to the tool and the vacuum
cleaner.
Get the tool and vacuum cleaner closer each other.
The maximum transmission distance is approxi-
mately 10 m however it may vary according to the
circumstances.
Keep the tool and vacuum cleaner away from the
appliances such as Wi-Fi devices and microwave
ovens.
Turn off the wireless activation button of the other
tools or cancel the tool registration of the other
tools.
Adjusting 0°-cut accuracy
NOTICE:
Before starting the setting, make sure
the lock of the cutting depth is firmly secured.
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1.
Loosen the bevel angle lock so that the bevel
angle can be changed.
NOTE: Refer to the section about bevel cutting for
how to tighten or loosen the bevel angle lock.
2.
Put a triangular rule or square rule onto the side of
circular saw blade and the base.
While keeping the side of circular saw blade and the
base perpendicular, turn the adjusting screw to make
0° position.
► Fig.37: 1. Triangular rule 2. Adjusting screw
3.
Lock the bevel angle and make a test cut to check
the verticalness.
Publicité
