Table des Matières
Publicité
•
You can sample data up to 100 times.
7. To exit the sampling operation, press J.
•
This displays an exit confirmation dialog box.
8. Press 1(Yes).
•
This displays a screen like the one shown below.
•
Specify the list where you want to store the data.
Input ... Specify the list where you want to store the horizontal axis data.
CH1, CH2, CH3 ... Specify lists where you want to store the sample data of each
9. After specifying the lists, press w.
•
This will cause the message "Complete!" to appear. To return to the Manual Sampling
screen, press w.
•
In the Statistics mode, sample data will be displayed as shown below.
Note
•
You can use trace while sampled data is shown on the graph. For details, see "Using
ε
Trace" (page
-40).
•
If "On" is selected for the sampling "Time Limit" setting, sampling will stop automatically if
you do not perform any operation for 90 minutes. In this case, the sample data is not stored
in a list.
ε
-32
Starting a Sampling Operation
channel.
Publicité
Table des Matières
