Publicité
14 | English
(16) Cable Clamp
(17) Filter
(18) Rainwater Pump
(19) Hose Connection
(20) Connecting Cable
(21) Plug
Technical Data
Rainwater Pump
Article number
Flow rate (Q)
Head pressure (H)
max. submersion depth
max. water temperature
Rated voltage
Water Ingress Protection
Weight according to EPTA‑Procedure
Serial number
Recommended ambient temperature during char-
ging
Permitted ambient temperature during operation
and storage
Battery type
A) Depends on battery in use
B) Limited performance at temperatures < 0 °C
The pump should only be used with the, GardenPump 18, battery control unit.
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Assembly
Fastening the Wall Attachment/Water Tank
Attachment (see figure B)
Fasten the wall attachment (10) next to the water tank. Note
that the distance to the water tank is limited due to the con-
necting cable length.
The distance to the water tank plus the water tank height
may not be larger than the length of the connecting cable.
When mounting the wall attechment to the wall, use the
guide holes to mark the position of the screws.
If wall mounting is not possible, the provided water tank at-
tachment (8) can be attached directly to the rim of the water
tank.
NOTE: The battery control unit is switched off via a thermal
switch at increased temperature. The attachment for the
F 016 L94 292 | (23.07.2021)
(22) Battery
(23) Battery Charger
(24) Cap
(25) Ball bearing
a) Accessories shown or described are not included with the
l/h
m
m
°C
A)
kg
°C
B)
°C
battery control unit should therefore be mounted in a
shaded position.
Inserting/Removing the Battery Control Unit
(see figure C)
In the case of wall attachment take out the securing
screw (9) from the attachment, attach the battery control
unit (6) from above into the wall attachment and secure it at
the bottom with the clip and securing screw (9).
In case of water tank attachment just clip the battery control
unit on the attachment.
Determining the required length of cable and
connecting hose (see figure D)
Note: The pump needs to be positioned 50 mm above the
base of the tank, clear of any sediment that might damage
the pump.
a)
product as standard. You can find the complete selection of
accessories in our accessories range.
GardenPump18V-2000
Pump
3 600 HC4 1..
1800
17,5
1,8
35
V
18
IPX8
0,8
see type plate on tool
0... +35
-20... +50
PBA 18V...W-.
1,5 Ah, 2,0 Ah, 2,5 Ah,
3,5 Ah, 4,0 Ah, 6,0 Ah
Battery Control Unit
3 600 HC4 0..
18
IPX4
0,6
see type plate on tool
0... +35
-20... +50
PBA 18V...W-.
1,5 Ah, 2,0 Ah, 2,5 Ah,
3,5 Ah, 4,0 Ah, 6,0 Ah
Bosch Power Tools
Publicité
