HumanTechnik CM-1 Mode D'emploi page 33

No. Control feature
1 12 V
voltage input
2 Charging cradle
for device
components
3 LED (blue)
LED (red/green)
4
5 Bridge element
connector slot
6 Bridge
element
Installation of the CM charger
1. Plug the power supply unit into the 230 V mains.
2. Connect the CM charger to the power supply unit by inserting the round con-
nector of the power supply unit into the DC jack on the back of the CM charger.
Function and application CM-1 charger
Jack for the power supply unit on the back of the
CM-charger.
3-pin charging cradle to hold the CM-1 transmitter
unit or CM-1 receiver unit upright.
Standby indicator lights
Charge indicator
There is a connector slot in the base under a plastic
cover. A bridge element can be pushed into it to enable
two CM chargers to be connected.
Bridge element for connecting two CM chargers
electrically.
Power supply is connected
red Battery is recharging
green Battery is fully recharged
English 33