HumanTechnik CM-1 Mode D'emploi page 27

Inserting the teleloop into the CM-1 receiver:
The CM-1 receiver can be used in two ways:
via the teleloop which is supplied
via a headset (not included in the scope of delivery)
In order to ensure successful transmission via a teleloop, your hearing aid must
have an integrated telecoil (T-coil) with which the sound information is transmit-
ted inductively to your hearing aid. Hearing aids generally tend to have a small
T/MT switch which can be used to set your hearing aid to inductive reception.
1. Insert the two plugs fully into the jacks on the top of the device. The marking
on the side of the plugs points towards the headset jack.
2. Turn the plugs through 90° so that the markings on the side point towards the
top of the device.
Teleloop (wound up)
Headset (not included in
the scope of delivery)
English 27