Publicité
Item:
LWRAPA2-25PCS
LWRAPA4-50PCS
LWRAPA2-25PCS-EM
LWRAPA4-50PCS-EM
LWRAPA-OS-PIR-BT
INSTALLATION INSTRUCTIONS
Final Installation Instructions:
Figure 20
Figure 21
**NOTE: THESE INSTRUCTIONS DO NOT ADDRESS ALL PERMUTATIONS THAT MAY EXIST IN INSTALLATION, MAINTENANCE, AND OPERATING ENVIRONMENT.
**REMARQUE : CES INSTRUCTIONS NE TRAITENT PAS DE TOUTES LES PERMUTATIONS QUI PEUVENT EXISTER DANS L'INSTALLATION, LA MAINTENANCE ET L'ENVIRONNEMENT D'EXPLOITATION.
**NOTA: ESTAS INSTRUCCIONES NO ABORDAN TODAS LAS PERMUTACIONES QUE PUEDEN EXISTIR EN EL ENTORNO DE INSTALACIÓN, MANTENIMIENTO Y OPERACIÓN.
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & Trademark of Southwire Company, LLC.
ARCHITECTURAL WRAP
800-666-2852 | SOUTHWIRE.COM
1. Swing the LED panel closed and fasten in place with the 2
screws removed during Pre-installation. See Figure 20.
2. Install the diffuser starting at one end of fixture base, insert
diffuser slot onto edge of luminaire housing. Carefully
squeeze diffuser to engage opposite side with luminaire
housing. Continue this action down length of diffuser until
fully installed onto fixture base. See Figure 21.
3. Turn on AC power.
Publicité
