Publicité
Item:
LWRAPA2-25PCS
LWRAPA4-50PCS
LWRAPA2-25PCS-EM
LWRAPA4-50PCS-EM
LWRAPA-OS-PIR-BT
INSTALLATION INSTRUCTIONS
Pre-Installation Instructions:
Fixture Base
Figure 1
Power Select Switch
Color Temperature(CCT) Select Switch
Figure 2
Figure 3
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & Trademark of Southwire Company, LLC.
ARCHITECTURAL WRAP
Diffuser
800-666-2852 | SOUTHWIRE.COM
1. Before installing or servicing any part of this fixture, turn off AC
power at the circuit breaker.
2. Remove diffuser by rolling it off of the edge lip all the way down
1 side. See Figure 1.
3. Set the diffuser aside carefully in a safe location.
4. If replacing a fixture, remove existing fixture and mark wires for
identification.
5. Determine which mounting method to use (junction box
mounting or keyhole mounting).
6. Select the desired CCT and power for the environment in which
the fixture is installed. See Figure 2.
7. Remove the 2 screws holding the LED panel. Allow the panel to
swing open. See Figure 3.
Publicité
