Publicité
Item:
LWRAPA2-25PCS
LWRAPA4-50PCS
LWRAPA2-25PCS-EM
LWRAPA4-50PCS-EM
LWRAPA-OS-PIR-BT
INSTALLATION INSTRUCTIONS
Figure 14
Figure 15
Figure 16
Figure 17
©2023 Southwire Company, LLC. All rights reserved.*Registered Trademark & Trademark of Southwire Company, LLC.
ARCHITECTURAL WRAP
800-666-2852 | SOUTHWIRE.COM
2.
Align the sensor endcap with the fixture endcap and pass
the wires from the sensor endcap into the fixture. See
Figure 14.
3.
Secure the sensor endcap to the fixture using the supplied
screws. See Figure 15.
4.
Make the following wiring connections using the supplied
push-in connectors:
purple wire to DIM+
pink wire to DIM-
yellow wire to 12V+
Shown in Figure 16.
Note: The Orange CCT wire should remain capped and
disconnected.
5.
Remove the protective cap from the sensor port by
rotating counter-clockwise 90° and lifting up. Install the
sensor to the sensor port by aligning tabs under the sensor
with the sensor port indentations, then rotate slightly
clockwise. See Figure 17.
Publicité
