Setting Colour Sequence (Code) - Sensopart IO-Box 50 C S1L8 Série Instructions De Service Et De Montage

5.8

Setting colour sequence (Code)

The "Code" mode enables the grouping of taught colours (channels) and the definition of a sequence within this
group.
The so-called colour code is then allocated to a freely-selectable output.
Press key 3 s until the submenu "Functions" appears.
Activate the key (next). The set-up mode can now be modified with the arrow keys. Set the "Code" mode and
confirm with the key (go).
Now all the colours (channels) which form the code can be selected one after the other. Select the appropriate chan-
nels with the (10s) and
(channels) have been selected, end the total code with
The total code can now be allocated to a freely-selectable output channel. Select the channel using the
and (units) keys and confirm with
The code assignment can now also be deleted if necessary. Select the output channel to which the code is allocated
and confirm with (del) and
If this is not required, end the complete process with the
The IO Box FT 50 C...S1L8 returns to normal operating mode.
If the code is detected, the output remains set until one of the colours contained in the code is detected again with
the exception of the start colour. Colours not contained in the code are ignored.
Example:
Code Code
1 2 3 4 1 2 3 4
Code Code
1 2 3 4 1 2 3 4
1= yellow / 2= green / 3= blue / 4= red / 5= dark grey / 6= violet / 7= light grey
Yellow (1): Start colour of the colour code in this example
Max. 4 colour sequences (codes) with max. 28 colours can be taught.
30
(units) keys in the correct order and confirm each with
(OK).
(OK).
Code Code
1 2 3 4 1 2 3 4
Colours not contained
in the code.
Are ignored!
5 2 3 4 1 6 3 4
(end).
key (end).
Code
1 2 3 4 1 1
Output is permanently on
Code
1 2 3 4 7 7
Output expires once a code colour
(not start colour) is detected
IO - Box FT 50 C...S1L8 D - 068-14325- 26.11.2009-00
Mounting and
operating instructions
(OK). If all the colours
Fig. 10
15501136
(10s)