Publicité
Built-in Outdoor Sear Burner Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install
built-in sear burner.
Failure to do so can result in back or other injury.
Unpack sear burner. Remove all packaging materials and
remove sear burner from carton.
Place sear burner into outdoor enclosure, but leave enough
room in back to connect to gas supply and electrical single
prong plug-in.
Install Tank Tray for 20 lb LP Gas Fuel Tank
For Models Equipped for Use with a 20 lb LP Tank
1. Position the tank tray for 20 lb LP gas fuel tank in the island
cabinet.
centerline of
tank tray
20⁵⁄₈"
(52.4 cm)
Sear Burner
2. Square the tank tray mounting brackets and mark the
mounting hole locations in the island base.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
A
18³⁄₈"
B
(46.7 cm)
Dimension A
Dimension B
8³⁄₃₂" (20.6 cm)
16³⁄₁₆" (41.1 cm)
3. Remove the top nuts (4) from the tank tray assembly and lift
the tank tray off of the mounting brackets.
4. Install the tank tray mounting brackets to the base or floor of
the island using the proper size and type of mounting
hardware (not supplied). Tighten mounting hardware.
(7.6 cm)
A. Screw (Use proper screw for island floor material.)
2¹⁄₄"
B. Lock washer
(5.7 cm)
C. Flat washer
5. Pre-adjust each of the bottom nuts on the mounting brackets
to 3" (7.6 cm) from the base of the island to the top of the
nuts.
6. Remount the tank tray back onto the mounting brackets.
Replace the 4 top nuts but do not tighten.
C
D
A. Top nut
B. Tank tray
C. Bottom nut
D. Bolt
E. Mounting bracket
A
B
C
3"
A
B
A. 20 lb LP gas fuel tank
B. Tank tray for 20 lb gas fuel tank
C. Top nut (do not tighten)
D. Mounting bracket
A
B
C
D
E
13
Publicité
